This Excelsior Was Plated Using Our Triple Chrome Plating Kit

Photos Taken & Digitized By Chris Storch, c/o Scooter Shooters by BLIND DOG PHOTOS, 1 Locust St, Suite C, Madison, NJ, 07940, (201) 765-0940

This BSA Shooting Star Was Plated Using Our Nickel Plating Kit

This 1966 TT Special Has 12 Parts Plated With Our Copy Cad® Kit

Owned By Bill Gotzmann - Restored By Fred Louws (905) 894-1579

Won First In Class 1963-1970 at Jefferson, PA Triumph Homecoming Rally 1997 And Had Some "Very Fussy Judges"

This Bike Has Parts Plated With Our Nickel Kit And Copy Cad® Kit

This 350 Yamaha Scrambler has parts plated with Copy Cad®

Owned and Restored by Sam Simons. Plating by Nelson Barlow.

Photo 1 - Shows the foot brake and rod, kick starter and rear wheel spokes

Photo 2 - Shows the circular side plate, which was given a spun aluminum look with fine steel wool on a lathe. Also the foot shift and rider foot peg are visible along with the forward engine mounts.

Photo 3 - Shows the turn signal mounts, along with the fuel tank cap, which was also given a spun aluminum look.

This 1965 Triumph has 850 small parts that have been chrome plated using our Chrome Plating Kit. The larger pieces have been chromed at a plating shop.

Owned and restored by Rainer Mueller

1974 Moto Guzzi plated with electroless nickel

My first contest/show was at the Prescott AZ Moto Guzzi rally. I actually won the first place trophy for my class (Early Round Head - Touring). The hardware certainly helped. - Gil DiSanto

Photos Of A Norton Plated With Triple Chrome

The shift lever, Oil tank cap, gas cap, break and clutch lever, and many "accessory" nuts and bolts were plated using your triple chrome plate kit. Thanks for the assistance. Regards John Head