This new kit has completely resolved this problem,
by using a new commercial grade system of etching, cyanide
free copper plating, and finally plating with our famous
Copy Chrome™ system. The system will also plate
pewter, lead, brass, copper, and steel model parts.
Previously painted parts should be immersed in any
conventional paint stripper to remove all traces of
paint.
Buff to a high shine using a cotton wheel and buffing
compound.
Place the SP Degreaser in a microwave and heat until
at least 140°F, immerse the part for about 2 minutes,
and then scrub off any heavy deposits with the brush
supplied.
Rinse in tap water and then immerse in the Pickle #4
for 1-2 minutes.
Wrap the bandages around the flat metal ends of each
plating wand.
Attach the positive lead (with the red plug) to the
copper wand.
Attach the black alligator clip to the object being
plated.
At this point, you can either brush plate the copper
on, or plate it in immersion. Flash Copper™ &
Copy Chrome™ solutions should be heated in a microwave
to approx 110°F.
To brush plate, thoroughly wet the bandaged wand in
Flash Copper™ solution and using slow strokes,
swab the entire surface of the object. Repeat the process
5 or 6 times to build up sufficient thickness of plate.
To immersion plate: Place the bandaged wand into the
plating solution and clip it to the container edge with
a clothes clip. Attach the object to the alligator
clip and suspend it in the solution. With Flash Copper™,
plating should be completed in about 2-4 minutes. With
Copy Chrome™, allow about 10 minutes. Turn the
part in the solution frequently.
Always plate with Flash Copper™ before attempting
to plate with Copy Chrome™.
Buff and polish the parts to a bright shine with Flitz.
 |
Kit contains:
- 1 Quart Flash Copper™ Solution
- 1 Pint Pickle #4 solution
- 1 x Quart Copy Chrome solution
- 1 Pint SP Degreaser solution
- 1 copper plating wand & bandage
- 1 Copy Chrome™ wand & bandage
- 1 x 4” shank mounted Buffing Wheel
- 1 x 5oz tube Flitz Polish
- 1 x large white buffing compound
- 1 x 1.5 volt a/c adapter
- Instructions
- Free Technical Support
|
|
